Thingiverse
Alice : Four Arm BJD
von zlytheis
2.8k
Downloads
2.9k
Likes
8
Makes
Four arm upper torso remixed by me.
Load the Chest Scale and remixed chest into your selected slicer and scale the remixed chest to match.
There are two versions of the Four arm chest; a "Sunk" version and a not "Sunk" version
The "Sunk" version have the lower arms sunk deeper into the chest, I have not tried to suede this version because the arm holes are quite tight and require you to pop in the upper arms. The version you see is the non-sunk version.
The tail is a lot longer than my previous BJD because I printed 26-36 twice and attached them together. Like 25-25-26-26-27-27-...-36-36-37-38-39
I was too lazy to sand and wanted to see what she would look like glossy.
This is a mix of multiple parts from multiple creators
Body: 3184441
Tail: 3800006
Tail tip: 2884250
Face: 2996049
The original modified lower torso was 403mb from meshmixer. This file is an auto-reduced version using a maximum deviation of 0.01
The lower body tail attachment is a meshmix of
Load the Chest Scale and remixed chest into your selected slicer and scale the remixed chest to match.
There are two versions of the Four arm chest; a "Sunk" version and a not "Sunk" version
The "Sunk" version have the lower arms sunk deeper into the chest, I have not tried to suede this version because the arm holes are quite tight and require you to pop in the upper arms. The version you see is the non-sunk version.
The tail is a lot longer than my previous BJD because I printed 26-36 twice and attached them together. Like 25-25-26-26-27-27-...-36-36-37-38-39
I was too lazy to sand and wanted to see what she would look like glossy.
This is a mix of multiple parts from multiple creators
Body: 3184441
Tail: 3800006
Tail tip: 2884250
Face: 2996049
The original modified lower torso was 403mb from meshmixer. This file is an auto-reduced version using a maximum deviation of 0.01
The lower body tail attachment is a meshmix of
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
