Alienware Area 51 alike pc case

This is a Alienware area 51 inspired case i desinged.
hardware:
M-ATX board with 10mm pcb standoffs.
standard ATX psu and mains extension lead
2.5 inch drive with 4 m3x8 screws(optional if m.2 drive installed)
front panel usb 3.0 ,usb 2.0, audio ,powerbutton with wire, and 12.7mm thick optical drive.
120mm fan for the back and 80-100 mm fan for the front grill
GPU less than 300mm long and 2 m3x8mm screws for mounting
and a extension 4 mains power jack.


instructions:
1.print all the parts and glue together according to the fusion file. this is now split up in pieces for printing. u need to adjust the oriantation by your self.requires a 200x200 bed to print the pieces
2.install the psu,make sure the wires come out the back. use small amount of hot glue enough to just hold the psu in place.(hot glue doesnt really stick to metal so u can remove the psu later if needed)install the extension lead as well.
3.mount the back fan with screws blowing out,and front fan with glue d