Thingiverse
Alignment Jig for Rogue Weight Stack Labels
door InTheRough
0
Downloads
0
Likes
0
Makes
LOTS of stickers!
When you buy a Rogue Functional Trainer - like the FM-6 - you have to place all of the stickers on the weight stacks. 116 for the Twin Stack and 58 for the Single Stack; not including the descriptive stickers. Cut down time and frustration with this alignment tool/jig.
This is best to do BEFORE installing all the weights but I didn't think to do that. If you don't do it before, it would be best to have an extra hand. It helps in lifting the stack by attaching a handle to the low row cable. Once I got down to the bottom, I had to one arm 'row' 150lb and place the alignment tool in at the same time.
You will want to print one and flip one in your slicer to align both sides. It only took 45 min to print in PETG.
Good Luck!
When you buy a Rogue Functional Trainer - like the FM-6 - you have to place all of the stickers on the weight stacks. 116 for the Twin Stack and 58 for the Single Stack; not including the descriptive stickers. Cut down time and frustration with this alignment tool/jig.
This is best to do BEFORE installing all the weights but I didn't think to do that. If you don't do it before, it would be best to have an extra hand. It helps in lifting the stack by attaching a handle to the low row cable. Once I got down to the bottom, I had to one arm 'row' 150lb and place the alignment tool in at the same time.
You will want to print one and flip one in your slicer to align both sides. It only took 45 min to print in PETG.
Good Luck!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!