AllSky_V2

A new version of my previous design.
The case is intended for ZWO ASI camera's with a 62mm body width and 35,5mm in height.
The inner components now grab into each other so it is easier to assemble when the case is already mounted.
In other words, stack all the inners parts on to the bottom lid and screw it into the main body, every component rotates with the lid so cables don't twist.
This case is designed for the dome found here : https://www.amazon.com.be/dp/B09B8BR5C5?ref_=pe_43847721_708903971_E_301_dt_1

Some components need supports, be sure to double check.

I have not yet printed the V2-parts myself.
The V1 case came out well and was printed in PETG and I've sprayed it with a clear satin lacquer.
It is now one week in use and constant rainy weather without problems.