Thingiverse
Aloris CXA chip pan mount
door fire4200
5
Downloads
2
Likes
0
Makes
Aloris CXA chip pan mount for my lathe
print flat with support but at support overhang angle 85° support is unnecessary for tapped holes support needed for square over hang
tapped holes are 1/4x20
there is 2 3mm holes in the top so if needed can insert stiffing rods into the thin section
printed with 4 wall lines cubic subdivided 40%
print flat with support but at support overhang angle 85° support is unnecessary for tapped holes support needed for square over hang
tapped holes are 1/4x20
there is 2 3mm holes in the top so if needed can insert stiffing rods into the thin section
printed with 4 wall lines cubic subdivided 40%
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
