Thingiverse
Alternative head for TV camera support
4
Downloads
4
Likes
0
Makes
What happen when it appear that a mast on my TV could be a good place for my remote controlled flash !
This two piece replace the threaded-rod upper end of the [TV support for camcorder](http://www.thingiverse.com/thing:1096886) and permit to tilt the supported object. Be careful, don't use it to hold heavy object : this support seem weaker than the original.
Additional needed parts (see picture):
* Wing nut M8: 1
* Big washer M8: 1
* Screw M8 hexagonal head 30mm: 1
This two piece replace the threaded-rod upper end of the [TV support for camcorder](http://www.thingiverse.com/thing:1096886) and permit to tilt the supported object. Be careful, don't use it to hold heavy object : this support seem weaker than the original.
Additional needed parts (see picture):
* Wing nut M8: 1
* Big washer M8: 1
* Screw M8 hexagonal head 30mm: 1
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
