Thingiverse
Always-Open Invisible Doorstop ™
von Petalesharo
11
Downloads
4
Likes
0
Makes
You ever have auto-closing doors you don't want to latch? Well here is your solution, available in all door sizes, and prints in JUST 15* minutes!
Just put on the leading edge or top of the door and you're good to go. The Always-Open Invisible Doorstop ™** works by wedging the door far away enough from the door-jamb that it won't allow the door to latch! The spring-arm also keeps it on whatever edge of the door you choose, while sliding off and on easily.
*: Times may vary per settings.
**: Not actually trademarked.
Just put on the leading edge or top of the door and you're good to go. The Always-Open Invisible Doorstop ™** works by wedging the door far away enough from the door-jamb that it won't allow the door to latch! The spring-arm also keeps it on whatever edge of the door you choose, while sliding off and on easily.
*: Times may vary per settings.
**: Not actually trademarked.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
