Thingiverse
Amazon Basics Tripod Plate
von Jeoncs
4
Downloads
5
Likes
0
Makes
Replaced a missing mounting plate on the standard Amazon basics tripod. The screw holes are m3 size. The tripod but I'm not sure on the thread but its one I had that had a 13 mm diameter on the head and is about 9 mm in total length. Printed the screw knob in PETG at .2 layer 15% infill and the rubber layer out of TPU at .2 layer and 15% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
