Amazon Basics USB3.0 Hub Raspberry Zero Case

Borrowed the raspberry case from DotNetWorker, but since I havn't had much luck printing snap fits in PLA, my lid is designed to be taped or glued in place.

This is a case for the zero which fits an off the shelf powered usb hub, that most people should be able to get, for now :P

I've used an amazon basics powered hub : https://www.amazon.co.uk/gp/product/B00E0NH7DQ/ref=oh_aui_detailpage_o04_s02?ie=UTF8&psc=1

Assembly Guide:

Step 1
: Take the hub apart, be careful not to snap off the delicate components insdide

Step 2
: Cut off the usb plug about 5mm off the board, we won't need it, just leave enough to see the colors of the wires.

Step 3
: Solder PP22 to the backside of the usbhub where the green wire goes in (USB D+)
: Solder PP23 to the backside of the usbhub where the white wire goes in (USB D-)
: Solder PP1 to the backside of the usbhub where the red wire goes in (USB +)
: Solder PP1 to the TopSide of the usbhub where the powerplug goes in,
the posi