Thingiverse
Amazon Echo Dot Wall Mount
by Mike01Hu
140
Downloads
73
Likes
2
Makes
This is another version of a wall mount for the Amazon Echo Dot printed using the following settings:
Layer height: 0.2mm
Perimeters: 3
Top and Bottom layers: 4
Infill: Rectilinear 50% (could be 100%)
Print with PLA at 205C nozzle and 60C bed.
You need to print the three brackets on their edge to ensure the grain is right for strength; the base needs to be printed with the slots uppermost. You may need a little gentle filing to fit the brackets and they will need to be superglued into position, then clean up the countersinks to ensure the fixing screws sit flush.
Layer height: 0.2mm
Perimeters: 3
Top and Bottom layers: 4
Infill: Rectilinear 50% (could be 100%)
Print with PLA at 205C nozzle and 60C bed.
You need to print the three brackets on their edge to ensure the grain is right for strength; the base needs to be printed with the slots uppermost. You may need a little gentle filing to fit the brackets and they will need to be superglued into position, then clean up the countersinks to ensure the fixing screws sit flush.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
