Ambient light case (for RP2040-Zero)

This is a 3D-printed case for an ambient lighting controller based on the RP2040-Zero. I use it with my PC setup, and it works well.

##What I used?
LED Strep WS2815 I used (2M 144 IP30 for my monitor) https://aliexpress.ru/item/1005005571899461.html
RP2040-Zero
Power connector 5.5x2.5mm (female)
Wires

##Software
I used Arduino IDE to program RP2040-Zero. Source code is [here](https://pastebin.com/zZiicUJE)
On the computer, I used Prismatik as the main ambient light software.

##Tips
It’s best to use 12 V LED strips instead of 5 V ones. On 5 V strips, you may notice significant voltage drop toward the far end, causing LEDs there to appear dimmer than at the start. If you still choose 5 V strips, make sure to feed power from both ends.