Slicer Discord
Amiibo Card case – 3D printable model from MakerWorld MakerWorld
Other Toys & Games

Amiibo Card case

37 Downloads
18 Likes
33 Makes
Go to Model
A case for Amiibo Cards! Holds up to 50 amiibo cards that measure: 21.4mm wide 31.2mm tall 0.8mm thick with a 2mm fillet Holds up to 50 cards, my set included 48 cards and that leaves a useful space to help separate the “done” from the “not yet done” when I'm scanning the cards. I saw a few other cases which were fine, but all had a similar issue: it's really difficult to get out one card at a time from them. So, using the cards means getting them all out, and slowly scanning and putting them back. Or fiddling in tight spaces with fat fingers (if you're me). This case allows you to pick out one card at a time, and move it around the case, scan it, move it to the “done” section. It's a fairly tight fit to avoid it being massive, the cards can freely move around in the case, but not too much. The lid friction fits tight so you don't have to play 48 card pickup. It's small and pocketable.
Category
Other Toys & Games
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

JamesCodesThings also publishes on

3 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

5 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection