Thingiverse
AMO Arrow Cutting Jig
292
Downloads
177
Likes
1
Makes
Adjustable arrow length sizing and cutting jig. The most basic component is a v-block and clamp with cutting guides for an X-Acto Razor Saw. This will hold arrows securely from 1/4" diameter up to 23/64" (and more). Note that you cannot over-tighten the clamp.
FOR WOOD ARROW SHAFTS - NOT RECOMMENDED FOR CARBON
The v-block is augmented with the other parts to allow instant arrow shaft measurements and consistent cutting.
At the nock end is an adjustable slider that provides 5" of arrow length variation (or 3" on the shorter version). Arrow lengths are measured using the Archery Manufacturers Organisation (AMO) standard from the base of the nock groove to the end of the physical shaft, before the point.
Two sizes of click-on nock locators provide a sturdy connection. The large nock locator has been tested with 5/16" Bjorn, Bohning, Gold Tip and Easton nocks. The small nock locator has been tested with 1/4" Bjorn and Black Eagle nocks.
A suitable length of wood is required
FOR WOOD ARROW SHAFTS - NOT RECOMMENDED FOR CARBON
The v-block is augmented with the other parts to allow instant arrow shaft measurements and consistent cutting.
At the nock end is an adjustable slider that provides 5" of arrow length variation (or 3" on the shorter version). Arrow lengths are measured using the Archery Manufacturers Organisation (AMO) standard from the base of the nock groove to the end of the physical shaft, before the point.
Two sizes of click-on nock locators provide a sturdy connection. The large nock locator has been tested with 5/16" Bjorn, Bohning, Gold Tip and Easton nocks. The small nock locator has been tested with 1/4" Bjorn and Black Eagle nocks.
A suitable length of wood is required
colinp_hughes also publishes on
16 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
