Amongus Candle remix

i clearly took his summary :

A mold for making candles.

This was a first test if this is a viable thing to do.

Candle making:

Print the mold
use Filler Spray on the inside
sand the inside to get a smoth surface
make the whole on the top wider to make it possible to insert molten wax later (did mess this up a little in the model)
spray the insides of the mold with oil (WD40)
put in candle wick
close mold
put tape around the edged
secure mold with rubber bands
insert molten wax
wait for it to harden (fridge helps)
open the mold and clean the model around the edges

Notes:

Blender File is included

Print Settings

Printer brand:

TEVO

Printer:

Tarantula

Rafts:
Doesn't Matter

Supports:
No

Resolution:
0.2 mm

Infill:
5%

Notes:

Bottom Layers: 0
Low Infill (~5%)
Infill Support: True