MakerWorld
3D Printer Accessories
Vai al Modello
AMS 2 Pro Lid Riser for Larger Spools
350
Download
114
Likes
148
Makes
This is a simple but effective mod for the new AMS 2 Pro. It allows you to use larger spools while still keeping the AMS 2 fully sealed and without scratching the lid. This is based on the V1 lid riser by DesignCraft, so all credit to him for the original design and inspiration. I have been using his AMS 1 risers on my X1 and P1s with great success, and wanted the same setup for the AMS 2 Pro but found out the lid size was different so I made this model. TPU for AMS is the ideal material for this as it has some flex. IMPORTANT NOTE!: Some people have commented about not getting a good seal. This is due to improper installation. You need to apply a good amount of pressure so the bottom rib goes all the way into the rubber gasket on the AMS. Click here to check out my AMS HT lid riser.
maxim3D pubblica anche su
20 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
