AMS Buffer Tube Guide/Release - BABufferGuide

Frame will print flat with no support. Tested ASA, and should work with ABS. PLA and PETG have also been tested and printed well. If you like, please ‘like’, follow and rate, or don't, no pressure. I thank you for your interest.I have several other 3D printer addons, including an AMS buffer guide, a filament chute, and a magnetic door seal for the P1S. You can check them out at Gomezgames2B upload page: https://makerworld.com/en/u/1906662470 ,…if you are so inclined. If the static PTFE tube (Left Side) does not lock in place, push the lock to the left (As shown in the included GIF)*** The included GIF shows a complete removal and installation. Watch the GIF to see how to install this device. *** To install the tube release on the moving side (the right side, accessed through the window on the AMS buffer) :1) Use a screwdriver or similar tool to hold the AMS spring back.2) Insert the printed small tube guide, long side first and slide the short side into the springTo install the fra