AMS Feeder Saver

This AMS Feeder Saver prevents the wear and tear of the AMS Feeder Funnel plastic. In addition to the AMS Feeder Saver, you will also need 4x min. 7-8mm PTFE tubes. These should be inserted before mounting. This can be a bit tricky, but with some precision, it is possible. After that, the PTFE tube should be secure. Make sure not to push the PTFE tube too far through. It should protrude a maximum of 1-2mm at the bottom. After that, the AMS Feeder Saver can be easily installed. The easiest way is to place it at an angle at the recess and carefully press until the AMS Feeder Saver clicks into place. However, do not apply too much force to avoid causing damage. You can gently pull on it to check if it is securely in place. To remove it again, you need to pull on the AMS Feeder Saver until it comes off. This will damage the clip mechanism, which may mean you need to replace it after removal.For printing material, it's recommended to use a sturdy material like PETG/ABS/ASA. PLA "can