Ams hanger- Reprack

I wanted to suspend the AMS off of the printer but didn't want to extend any wire or tubes. I made this to suspend far enough where nothing needed to be modified and far enough from the wall so the lid stays open.The holes are sized to fit snugly with ½" EMT. There are through holes to either screw the hangers to the EMT, or run a continuous pin. The file was too large to print one piece on my P1S, so this was also my first attempt with using the cut feature in Bambu. The pieces are then lined up and superglued. The holes for the EMT are a 10mm deep blind hole.