AMS HT Drawer Riser

AMS HT Drawer Riser 1, 2 or 3 Drawers This is a simple drawer riser for the AMS HT. Also fits the Creality Space Pi it just slides back and forth a bit. Add simple drawers that take up just as much space as the HT already does. Vent hole on top of cabinet and vent in the back allow the AMS HT to get air. Drawers are cut short to not block the vent in back. The 3 drawer is a large print and takes up almost the entire width of the 256 plate, so you need to make sure you have good bed adhesion to avoid warping. I suggest turning off the part cooling fan for the first 10-15 layers and raising your bed temp 5-10 degrees. If you don't want the zipper sound when opening and closing the drawers I suggest using this drawer slide tape on the bottom of the drawers and on the inside of the frame where the tops of the drawer rub the sides. https://www.amazon.com/dp/B0C9MB2RM1?th=1 Cabinet and drawers all print in 2 pieces