AMS Hub Side Mount

I have my AMS below my printer on a wire rack and wanted a lower mount that was vertically oriented for the AMS hub, so I drew this up. It uses one of the screw holes on the back of the frame and some magnets to stay aligned… But honestly you can just use the screwhole… Steps are pretty simple:Print itPut in M3-H4 threaded inserts into the deeper part of the holes on the shorter rounded mounts for the AMS HubScrew on your AMS Hub into those holesMount the AMS onto the printer unscrewing the two outer frame screws and screwing this in.v1 - used magnets and one screw hole ← UNSTABLEv2 - switched to using two screw holes, dropped the magnets; and curved the support to match the X1C outer radius