AMS Hub Support

Failed to extrude filament. I had trouble feeding my A1 extruder with filament. Bambu was very helpful in trying to figure out the issue, which seemed to be that the extruder wheels had shifted. I put them back in the right place, but after a short while, the wheels shifted again. I then concluded that since the tubes were bending quite close to the AMS hub, the filament was being pushed down a bit crooked, which put undue stress on the extruder wheels. I then tried a prototype of this model, and after using this adapter, I haven't received the error message even once. Maybe it can help someone else out there! :) OBS - Make sure to reach deep down into the model when try to loosen the support. Dont want any material left to blocking the path of the tubes. Update: Of course, you can flip the object in the slicer to print it without support. However, for me, it was important to have a good finish on the top side and the hole pattern to reduce wear on the AMS-tubes. But this is a choi