AMS Lite Overhead Mount using TV Wall Mount

Updated 9/19/24 - Added New plate for a mounting bracket that can be oriented horizontally or vertically on the TV wall mount rather than just the original horizontal mount. __________________________________________________________________________________ My model adapts an AMS Lite to a TV wall mount arm to allow for placement overhead of the printer. I print it in PA6-CF so it's plenty strong with the settings in the profile. If you use other filaments you might need to consider the strength settings. The specific TV mount is the Armstrong full-motion mount sold by Harbor Freight for around $30. It has a Vesa plate that it comes with that this model replaces. If you use that plate it will conflict with the spools. This model matches the 3 hole pattern of the plate so it connects to the arm in the same fashion. Between this model and the arm, you'll use the short spacers that comes with the TV mount and a few washers to take up the gap you'll see in one of my photos. You'll need 3, 1