AMS Lite PTFE Quick Disconnect

This is a PTFE tube quick disconnect to be mounted on the AMS Lite extruders. It is designed to take a PC4-M6 PTFE tube connector and uses (8) 6mmx2mm magnets. It clips onto the extruder input on the AMS Lite to allow you to run PTFE tubes to the AMS Lite and be able to easily feed the filament in. I had a need for this after I printed the AMS Mini so that I could feed directly from my filament dryers into the AMS Lite. The AMS Mini can found here (it is awesome): https://makerworld.com/en/models/695403 I got inspiration from this model, but it was difficult to get the filament into the extruder without having to remove the tube from the PTFE connector: https://makerworld.com/en/models/557716 To install, slide the end of the receiver with the shorter tab onto the AMS Lite extruder side that has the larger gap. It should click into place. The threads for the PTFE connector is not perfect, so you have to be a little careful threading them on to keep them as straight as you can. I printed