AMS Spool Nameplate Label

Because I’m old and forgetful I designed a label system for my AMS. It’s simple, and my first design I’ve ever uploaded/shared. Also, I’m new to 3D printing and Fusion, so don’t have too high expectations. (Everything can be improved, right?) Hope it works for you. Inside Bambu Studio you have limited information on the device tab for the AMS, and I often find I forget whether I have matte installed, or regular, or plus…or even the right color…especially with white, clear, gray, or silver. With this identifier system, I can just glance up over my monitor and see. Again, simple, but it works. I tried to make it similar in appearance to the AMS layout on the Device tab of Bambu Studio. To adhere the nameplates to the AMS, I used 3M painters’ tape on the AMS itself, and then applied the 3M Double Sided Foam tape (3M 4026) on top of that to hold the nameplate. This way I can remove them later without marring up the AMS if a better system comes along. (See the attached pictures.) I also use