Thingiverse
Anbernic RG353M Controller
von PotatoMade
1
Downloads
1
Likes
0
Makes
The controller is loosely based off of the PS5 controllers.
The version I printed was done with Overture High Speed TPU. This gave it enough flexibility to allow for the device to slip into position and stay locked in place.
I didn't think to ask my buddy for pictures of it actually holding the RG353M, but I did make a rough model of it in order to make the controller.
The charging port and one other port are accessible when its in place. The speakers also have openings at the bottom in order to allow audio through.
The version I printed was done with Overture High Speed TPU. This gave it enough flexibility to allow for the device to slip into position and stay locked in place.
I didn't think to ask my buddy for pictures of it actually holding the RG353M, but I did make a rough model of it in order to make the controller.
The charging port and one other port are accessible when its in place. The speakers also have openings at the bottom in order to allow audio through.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
