Thingiverse
Anchor Lamp
por Solid_State__
9
Descargas
6
Likes
0
Makes
A future lamp project for my house. I still have a little more I want to add to this project, this is just preview. Ill post more photos as the process goes along.
*UPDATE(11/28/16)*
1st print attempt was a success. I had to use a large raft due to warping problems that I usually have with T-Glase. Other than that everything went really well. I have a lot of plans for this little lamp project so stay tuned. After all of the wings have been printed, I plan on adding some mechanical properties to this project. The total print time for this test was about 7 hrs, and I had the quality and support resolution really low, but the end results were great.
*UPDATE(11/28/16)*
1st print attempt was a success. I had to use a large raft due to warping problems that I usually have with T-Glase. Other than that everything went really well. I have a lot of plans for this little lamp project so stay tuned. After all of the wings have been printed, I plan on adding some mechanical properties to this project. The total print time for this test was about 7 hrs, and I had the quality and support resolution really low, but the end results were great.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
