Anemometer by Ramiky (small remix)

Original here:
https://www.thingiverse.com/thing:2966986

Just a couple small changes to Ramiky's original design:
On the cup holder top, the insde rotating portion of the 608 bearing was rubbing, so I opened up a 15mm x 0.5mm indention to allow better rotation of the 608 bearing. I also decreased the size of the hole that goes around the circumference 608 bearing. The 608 bearing now snaps into place.

I increased the diameter of the upper portion of the rod that fits into the 608 bearing for a tight fit. I sanded just slightly after printing for a nice snug fit.

Overall it looks good! I doubt the PLA will hold up to Texas heat, but we will see!