Thingiverse
Anet A2 X-Axis Cable Chain Attachment
von hartmann1301
22
Downloads
16
Likes
0
Makes
Some parts to attach an energy cable to the x-Axis of the Anet A2.
The part where the energy cable starts next to the first z-Axis is not perfekt. I had to use hot glue to make it work well.
15.05.2018: I edited this part a bit, it should be better now.
The slider-screw at the end the energy cable needs to longer than the original one. This was no problem for me because I used already a long one because of the belt-tensioner.
It fits to the cheap 10x10 energy cables you can by from ebay. (or somewhere else)
The part where the energy cable starts next to the first z-Axis is not perfekt. I had to use hot glue to make it work well.
15.05.2018: I edited this part a bit, it should be better now.
The slider-screw at the end the energy cable needs to longer than the original one. This was no problem for me because I used already a long one because of the belt-tensioner.
It fits to the cheap 10x10 energy cables you can by from ebay. (or somewhere else)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!