Thingiverse
Anet A6 BLTouch/3Dtouch mount
door quanticchaos
11
Downloads
3
Likes
0
Makes
22/03/18 Note:
Added V2 version.
V2 version has a removable holder so you can use the base to hold other kind of sensors (I'll make one for an inductive sensor which I want to try soon).
V2 also has more belt clearance, has an (almost) aligned Y position with nozzle and you can use the new BLTouch version.
I made this mount to be able to have a variable height mount for my sensor because the height of my nozzle is not always the same... I also created a calibration block of 8.3mm which is the recommended distance between the bed and the sensor body (lower you nozzle until it touches the bed, then place the block, adjust the sensor height and tighten the bolt -not too much-).
You'll need some 3M bolts (and possibly washers) to attach it to the extruder carriage and another for the sensor.
The X offset for the probe will be 35mm.
Added V2 version.
V2 version has a removable holder so you can use the base to hold other kind of sensors (I'll make one for an inductive sensor which I want to try soon).
V2 also has more belt clearance, has an (almost) aligned Y position with nozzle and you can use the new BLTouch version.
I made this mount to be able to have a variable height mount for my sensor because the height of my nozzle is not always the same... I also created a calibration block of 8.3mm which is the recommended distance between the bed and the sensor body (lower you nozzle until it touches the bed, then place the block, adjust the sensor height and tighten the bolt -not too much-).
You'll need some 3M bolts (and possibly washers) to attach it to the extruder carriage and another for the sensor.
The X offset for the probe will be 35mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
