Thingiverse
Anet A6 LCD padding frame
door pyctam
86
Downloads
35
Likes
1
Makes
My Anet A6 printer has LCD display with backlight panel out of its enclosure, so it stays uneven in the slot.
This padding frame should adjust/level LCD display placement and make it look even in the slot.
**Important!** Make sure that your slicer has scaled model to dimensions exactly as in drawing above (L: 90.5, W: 59.5 H: 3.5). In my case either slicer (Cura 3D) or onshape.com (when exporting as STL) tend to make model little bit longer or wider, so LCD display enclosure were not able to fit initially into the frame. I also suggest to print a draft with 1mm thickness and see if you printer prints the frame as expected.
P.S.: model sources are publicly available on http://bit.ly/2b4gEvG
This padding frame should adjust/level LCD display placement and make it look even in the slot.
**Important!** Make sure that your slicer has scaled model to dimensions exactly as in drawing above (L: 90.5, W: 59.5 H: 3.5). In my case either slicer (Cura 3D) or onshape.com (when exporting as STL) tend to make model little bit longer or wider, so LCD display enclosure were not able to fit initially into the frame. I also suggest to print a draft with 1mm thickness and see if you printer prints the frame as expected.
P.S.: model sources are publicly available on http://bit.ly/2b4gEvG
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
