Anet A6 Power Switch

Anet A6 power switch
---------------------
I was not able to find an existing thing to install a power switch at the back of the printer for the original power supply so i created this one.

### Installation
The top hole of the switch was designed to align with the hole at the power switch thats why you need 40mm screws. Because of the small space its a bit hard to fit the screw at the inner side. i used a short (~9cm) screwdriver for this. Since i am not an electronics expert i was not aware that the switch comes without a fuse so keep that in mind. Because the power supply is specified as 12V 20A it could provide 240W at max. That means at 230V there is at max 1A. So i think my spare fuses marked 1.6A 250V should be sufficient.

used switch:
https://www.amazon.de/gp/product/B01ID44I4S/

used screws:
* 2 x M4, 40mm (switch)
* 2 x M3, 30mm (to replace existing but shorter screws)
30mm fits but feels a bit short, 35mm should be perfect.
* 1 x M3 (inner side, existing screw