Anet A8+ bed adapter

Needed a new bed for my Anet A8+ couldn't find a original one
The closest in size I found was the Cr-10 bed on Amazon wich is 310x310 and uses the same resistors and thermistor.

The only issue i had was that the holes of the normal bed frame didn't match the new one so I designed a adapter that goes over the normal bed frame and reused the old corner holes to mount the new brackets

I would also advise to use PETG as the adapter will always be under the heat of the bed.

I also used some glue between the frame and the adapter pieces

you just need to print 4 of each as the oriantation doesn't matter


P.S. Don't forget to do a PID tune your new bed