Anet A8 bed level calibration test

This is the test I came up with for my Anet A8 bed level.

It goes all around the bed 2 times and prints 2 10x10x5mm cubes in the center.

It prints 2 lines right next to each other.

If your bed level is on point, you can see a small gap between them. (picture 1)
If it's to low it presses the lines into each other. (just a bit is fine - picture 2)
If it's to high, you will see the filament not sticking to the bed.

No brim, raft, rift! No infill!

Turned out to be a pretty good testing methode.