Thingiverse
Anet A8 Corner brackets/mounts V2
door MakeCents
8
Downloads
3
Likes
0
Makes
I made these corner mounts to hold my spools. Added my vertical and remix of the rolling spool holders that mount to the spinning cross bar.
Corner pieces: Put the rear in first, then start the center and gently snap in the side while pressing down the center.
Spinning part: Has extra lines to sand for preferred resistance in spin.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/4vHkne4hk8Z
Corner pieces: Put the rear in first, then start the center and gently snap in the side while pressing down the center.
Spinning part: Has extra lines to sand for preferred resistance in spin.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/4vHkne4hk8Z
MakeCents publiceert ook op
12 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
