Anet a8 External case for electronics

UPDATED 17/09: Added version v2 with lower bottom layer and honeycomb grid on the sides. Made for use less material.

Remix of this AM8 case https://www.thingiverse.com/thing:2510441 that was a remix of original https://www.thingiverse.com/thing:2199806 from wich took parts for do his external case.

Adapted to be printed with A8 stock (21.5cm lenght of box).

I'm, making a enclosure and in order to pull any electrical part out of enclosure i modified da box.

Space for MB Anet v1.0, 5 buttons LCD, 1 mosfet. fused switch and PSU. There is space for install one other mosfet or one raspberry PI but need to be modified. Easy job to do. I want my pi inside and got only one mosfet so is adapted to my needs. 1 80mm fan hole at the back and side and tope grill for air circulation. Carefull inside is only 20.5 cm...so it fit only the stock psu and is tight asfuck. IT does not get stuck but is just right. I think i will remove fron grill of psu so that there is more air going around..