Anet A8 extruder Bracket

After many iterations and experimental designs, finally concluding to a crown design for the job.

Some people had doubts of play, the heat and durability, but using V2 over a year had no problems at all, 10-hour prints not a glitch.

then made iteration which V3 printed V4 and so on, worked out well and made an adjustment and redesign overall.

This V9.9 has 2 versions, Reverse and Original.
I'm using the reverse as my setup doesn't allow me to see the extruder on the original orientation. and also, brings the extruder to the corner, to see it clear while bed levelling.

UPdates
- one part
-easy assembly
-tight tolerancing
-25mm more on Zaxes
-central mass
-cable management

- 5/7 hour print time depending on the setup
-built on supports

on the V9.9, you do need to zip tie the belt to fasten and add tension. I found it easier to tighten the belt first, then attach it to the carriage after. they're by the belt is always tight and easy to adjust.

If you manage