Anet-A8 Front Brace table Clamp

I wanted to see if i could secure the front of my printer without having to resort to screwing it down. i'm using [thing:1857991][1] as a front brace. These two parts fit over a 19mm board (an Ikea wardrobe shelf) and the two side pieces hold the printer secure even without the clamps over the bars (they sit just on top of the brace part). Even adding one made a difference to the vibration.

Should print OK without supports. Use M3 bolts, and tap the holes.

[1]: https://www.thingiverse.com/thing:1857991