Thingiverse
Anet A8 Laser Mount
by 3D_Pressure
14
Downloads
12
Likes
0
Makes
A mount to hold an engraving laser on your Anet A8 print head.
The thing listed as source did not fit, so I redesigned it with correct measurements.
The laser is mounted at a very slight angle on my setup (as it is only hold by two screws), which will not matter for engraving, but might be an issue for laser cutting.
As always, any kind of feedback is welcome.
The thing listed as source did not fit, so I redesigned it with correct measurements.
The laser is mounted at a very slight angle on my setup (as it is only hold by two screws), which will not matter for engraving, but might be an issue for laser cutting.
As always, any kind of feedback is welcome.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
