Anet A8 LCD Flush Mounting Frame

This is a flush mounting frame/cover for a standard Anet A8 LCD screen for custom installs . ( part LCD2004) It allows you to mount the LCD on a flat panel with the only hole needed is for the ribbon cable access . This saves a lot of time marking & drilling all the holes & cutting & filing the square LCD panel hole .
There are spacers on both sides of the PCB to hold everything at the right height. Print 2 of the small stepped spacers to hold the PCB board inside the cover . The whole assembly attaches with 4 x 4G x 25mm long screws through the cover , PCB board & printed spacers . If your mounting it to conductive plate , put some insulation behind the header pins in case of a short .

UPDATE: there is a nice backing plate designed by truglodite to mount the whole assembly on to. Its available at
https://www.thingiverse.com/thing:2861929

UPDATE : added a desktop angled backing plate stand to allow the controller to sit on a desktop.