Anet A8 LCD hinged cover

I was going to sleep the other night, I had an overnight print going, and I noticed the LCD on my Anet A8 was very bright, so for the time being i taped some playing cards to the LCD screen, however this was unsightly, so when i woke up the next morning I sketched up a design and then created it in Fusion 360, it took a little bit of trial and error and the file you are getting is actually better than the one I have attached on my printer, I just did not feel like printing another one because the one I attached is good enough. I would suggest you use a filament color other than white because the light still shows through this somewhat, but if you only have white like me then tape something opaque to the inside of the cover, that way the light does not shine through. Make sure your bed is covered in hairspray or whatever you use to make prints stick because the cover itself likes to warp if it is not properly adhered to the bed. Any ideas to improve this design will be welcome, if you h