Thingiverse
Anet A8 Nested LCD Backplate
by MegaDman98
22
Downloads
17
Likes
0
Makes
Once installed you will not need a pair of pliers to remove the lcd screen
-You Will Need-
(4)The original M3x30mm mounting screws should work fine, but to make the screws flush with the backplate I switched them to be M3x20mm
(4) M3 Nuts
(1) Pair of pliers
-Optional-
If you cannot get the M3 nuts to nest into the backplate with a pair of pliers use a soldering iron to push the m3 nuts into place (tested)
-You Will Need-
(4)The original M3x30mm mounting screws should work fine, but to make the screws flush with the backplate I switched them to be M3x20mm
(4) M3 Nuts
(1) Pair of pliers
-Optional-
If you cannot get the M3 nuts to nest into the backplate with a pair of pliers use a soldering iron to push the m3 nuts into place (tested)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
