Thingiverse
Anet A8 - Sensor Support
28
Downloads
23
Likes
0
Makes
Two pieces rear support for 13mm inductive sensor.
No support required.
4 M3 needed.
Below the Marlin settings:
**define X_PROBE_OFFSET_FROM_EXTRUDER +21 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 59 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]**
**define LEFT_PROBE_BED_POSITION 5
define RIGHT_PROBE_BED_POSITION 195
define FRONT_PROBE_BED_POSITION 50
define BACK_PROBE_BED_POSITION 205**
No support required.
4 M3 needed.
Below the Marlin settings:
**define X_PROBE_OFFSET_FROM_EXTRUDER +21 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 59 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]**
**define LEFT_PROBE_BED_POSITION 5
define RIGHT_PROBE_BED_POSITION 195
define FRONT_PROBE_BED_POSITION 50
define BACK_PROBE_BED_POSITION 205**
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
