Thingiverse
Anet A8 Small Front Brace
von kelmi92
14
Downloads
13
Likes
0
Makes
There are many front frame braces over thingiverse, but all of them are attached to the laterar thread rods. I have my Anet anchored to a base, so I didn't need a large front frame because I could anchor the frame to the base too whit a couple of screws, so I design this model.
The screw holes are made for 3mm wide screws. The length of them depend of the thickness of your base.
The screw holes are made for 3mm wide screws. The length of them depend of the thickness of your base.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
