Anet A8 Spool Arm

Very simple but effective filament spool holder for the AnetA8 designed in Google SketchUp.
I suggest printing a spool cap for your spool so the spool doesn't wobble on the threaded bar.

Settings I used to print this.

PLA
Temp: 200 degrees
Thickness (Wall/Top/Bottom): 0.8mm
Layer Height: 0.3mm
Infill: 25%

I also created a 4mm brim but it's not needed I just have poor masking tape.


NOTE: The slot on one side is bigger than the other side the slightly longer one is for the threaded bar, the shorter one is so it doesn't hit the screen circuit board.