Anet A8 Strain Relief

**General information**

This is a strain relief for the Anet A8 heating bed connector. Due to the normal movement of the heating bed, individual pins of the plug may not contact properly. In the worst case, contact problems can lead to high heat generation inside the plug.

This strain relief prevents movement on the plug and thus on the pins. The six leads of the heating bed are guided cleanly and the pins in the plug are decoupled from the movement of the heating bed.



**Requirements**

The strain relief has been designed for the "Bohrers" heating bed holder in combination with the "Bohrers" silicone buffers.

The printer must have the following parts installed:

Heat bed holder
Silicone buffer



**Needed Parts**


1x M4x8 screw
1x M4 nut
2x M3x10 screw
2x M3 nut



**Disclaimer**

I assume no liability for damage caused by improper use, incorrect commissioning, unsuitable accessories or failure to observe the safety precautions.
The strain relie