Thingiverse
Anet A8 Switch Panel
door rpatten
12
Downloads
6
Likes
0
Makes
A switch panel I made for my Anet A8. Holds 3 Standard 3/4" Rocker Switches. Illuminated or not. and has a hole on the back to feed the wires in and out.
Mounts on the top of the Anet A8 with 3M VHB double sided tape, and upper section is built at an angle to mount the Official Raspberry Pi 7" Touchscreen Housing or a 3D printed copy of it.
There is a relief on the bottom that lines up with a screw in the stock frame.
Prints without any support as long as you have your settings right for halfway decent bridging for the roof.
Mounts on the top of the Anet A8 with 3M VHB double sided tape, and upper section is built at an angle to mount the Official Raspberry Pi 7" Touchscreen Housing or a 3D printed copy of it.
There is a relief on the bottom that lines up with a screw in the stock frame.
Prints without any support as long as you have your settings right for halfway decent bridging for the roof.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
