Thingiverse
Anet A8 Z stepper alignment indicator
von dugacki
2.2k
Downloads
1.5k
Likes
14
Makes
#####Problem:
On Anet A8 the left and right z steppers get misaligned (skip a step). This can happen because the screws aren't running smoothly or if the printer isn't assembled/aligned perfectly. I've had problems on almost every print with this when I first got this printer. Now that I got things running smoothly this only happens sometimes, usually on long prints, when moving the printer changing the filament etc.
#####What the thing does:
The indicator shows if the left and right steppers are aligned with each other or not. If they are not you can easily realign them.
If your printer is tuned correctly you almost never need to realign the steppers, if it does you should fix the problem by cleaning, lubricating, aligning z lead screws and rods.
#####How to use the thing with your Anet A8:
Print 2 rings and 2 bases.
On both z axes, put the ring part on the lead screw and attach the base part with one screw on the printer (as seen on photo). The ring should
On Anet A8 the left and right z steppers get misaligned (skip a step). This can happen because the screws aren't running smoothly or if the printer isn't assembled/aligned perfectly. I've had problems on almost every print with this when I first got this printer. Now that I got things running smoothly this only happens sometimes, usually on long prints, when moving the printer changing the filament etc.
#####What the thing does:
The indicator shows if the left and right steppers are aligned with each other or not. If they are not you can easily realign them.
If your printer is tuned correctly you almost never need to realign the steppers, if it does you should fix the problem by cleaning, lubricating, aligning z lead screws and rods.
#####How to use the thing with your Anet A8:
Print 2 rings and 2 bases.
On both z axes, put the ring part on the lead screw and attach the base part with one screw on the printer (as seen on photo). The ring should
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
