Thingiverse
Angle brace for RC airplane
von roefoo
22
Downloads
9
Likes
0
Makes
This is an internal 90° angle brace for "foamie" RC airplanes using square foamboard tubes. In particular, I designed this piece for an [Experimental Airlines Axon](https://youtu.be/-gFYDk5QFhQ) to keep the fuselage tubes square and prevent racking.
The braces weigh about 1.2 g each (PETG), and install easily with hot glue. A pair of braces will fit side-by-side (see photo) in a nominal 68-70 mm (external) square tube made of Dollar Tree foam board.
They also work as mini-bulkheads for mounting small components, and have three small holes for routing wires, pushrods, etc.
The braces weigh about 1.2 g each (PETG), and install easily with hot glue. A pair of braces will fit side-by-side (see photo) in a nominal 68-70 mm (external) square tube made of Dollar Tree foam board.
They also work as mini-bulkheads for mounting small components, and have three small holes for routing wires, pushrods, etc.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!