Thingiverse
Angle Measure Tool
door SeanSlc
20
Downloads
14
Likes
0
Makes
Hello. This is my first prototype of my angel measure tool. It is in early development so its not 100% perfected yet! The measurement may be a few degrees off however I'm working on it
You will need to drill a small hole down the round piece in the center of the model so i would recommend a 100% infill and a little bit of a scale up wouldn't hurt!
If you have any feedback feel free to reach out or comment
You will need to drill a small hole down the round piece in the center of the model so i would recommend a 100% infill and a little bit of a scale up wouldn't hurt!
If you have any feedback feel free to reach out or comment
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!