Thingiverse
Angle Setter for knife sharpening systems (Tormek, Scheppach ...)
von Glloq32600
6
Downloads
12
Likes
0
Makes
Angle setting tool for water grinders (Tormek, Scheppach, etc.), similar to the KS-123.
1 - Place the tool on the grinder’s universal support and adjust its length to match the knife support tool + the knife. Tighten the knob to lock the length.
2 - Adjust the height of the grinder support until the angle indicator points to the desired angle, while keeping the three contact points between the tool and the grinding wheel in contact.
3 - The adjustment is complete — remove the tool.
Print the 5 parts. To assemble them, you will need:
- 3 × M4 nuts. Preferably use 2 lock nuts (for the “pointeur” and the “support”) and 1 standard nut for the “bouton”.
- 1 × M4x12 hex head screw for the “lien barre”.
- 2 × M4x10 pan head screws.
- 1 rubber band, approx. 75 mm long.
Do not tighten the pan head screws fully, to allow free translation and rotation.
1 - Place the tool on the grinder’s universal support and adjust its length to match the knife support tool + the knife. Tighten the knob to lock the length.
2 - Adjust the height of the grinder support until the angle indicator points to the desired angle, while keeping the three contact points between the tool and the grinding wheel in contact.
3 - The adjustment is complete — remove the tool.
Print the 5 parts. To assemble them, you will need:
- 3 × M4 nuts. Preferably use 2 lock nuts (for the “pointeur” and the “support”) and 1 standard nut for the “bouton”.
- 1 × M4x12 hex head screw for the “lien barre”.
- 2 × M4x10 pan head screws.
- 1 rubber band, approx. 75 mm long.
Do not tighten the pan head screws fully, to allow free translation and rotation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
